Now I will take the Push/Pull tool and drag this section in an inward direction and enter the pull value as 4’’- 0.25’’ = 3.75’’ for having a hollow section in this cupboard. Just take this tool from the tool panel.Īnd first, click on the start point of dimension, then endpoint, and drag it in an upward direction for seeing it properly. If you want to remember the dimensions of your model, then you can mention dimensions on your model with the Dimensions tool. Then, if you drag the mouse cursor from right to left, it will select the whole object you drag it. Now select all guidelines and delete them. Now delete all the lines which we have drawn with the line tool.Īnd with the help of a line tool, draw plywood board thickness like this which divides this cupboard into sections. Repeat it from the guideline for the next section. So I will take a tape measurement tool and add a guideline at 3.167 distances. You can see the height of this cupboard is 10’’ and if we leave the thickness of plywood board from both sides that is 0.25’’ + 0.25’’ = 0.50’’ then it will be 9.5’’ left so you can divide this left dimension into three sections that are 9.5/3 = 3.167. I will divide the right side section into three parts. Now I want to divide the left section of this cupboard into two sections so that I will draw the line at the center of this section.Īnd draw two guidelines so that I can create a 0.25’’ thickness board here also. I am drawing these guidelines because I want to create a plywood board of 0.25’’ thickness at the center of this cupboard. I will do the same on the left side of this centerline. Now take the Tape Measurement tool and click on this center line, then drag the mouse cursor in the right direction and enter the value as 0.125’’, which is half of. Now I will click on the right view icon for the right view, and this will show me the front face of this cupboard. Now take the Line tool and draw a line in the center of this face from upper mid-point to lower mid-point.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |